ITC Limited

!
With its fully sealed, leak-free and corrosion-resistant characteristics, the magnetic pump is widely used in petroleum, chemical, pharmaceutical, electroplating, environmental protection, water treatment, film and television printing, national defense and other departments to pump easily It is an ideal pump for creating leak-free, pollution-free civilized workshops and civilized factories to handle flammable, explosive, toxic and precious liquids. The following matters should be considered during the installation process of the magnetic pump
Place the unit on the foundation, place a pair of wedge pads between the bottom plate and the foundation, and adjust the wedge pads to align the level of the pump. After adjustment, tighten the anchor bolts. The pump and motor should be inspected before installation. All parts should be intact and there should be no debris in the magnetic pump. Prepare the concrete foundation according to the foundation size and bury the anchor bolts at the same time. The suction and discharge pipelines of the force pump should have brackets and cannot be supported by magnetic pumps. The diameter of the inlet and outlet pipes should be consistent with the diameter of the pump inlet and outlet. After the installation is completed, finally turn the magnetic pump coupling by hand to check whether there is any friction. If the rotation is easy and even, the installation is complete. The pump is strictly prohibited from pumping media containing particles and easily crystallized. It is not allowed to operate continuously with the discharge port closed, and the minimum flow rate must be maintained. To prevent debris from entering the magnetic pump, a filter should be installed at the inlet, and the filtering area should be greater than ~ times the cross-sectional area of the pipeline. Expo Magnetic Pump Mainland Distribution, series (glass fiber reinforced plastic) suitable for OEMs of small magnetic drive pumps for OEMs and general applications.
This mode has flow rates up to cm/min. Ceramic bushings and bearings are used as standard wear parts to increase service life. Standard fittings for hose, thread or kit. Series (ordinary type) small magnetic drive pumps suitable for semiconductors use polyethylene to naturally connect the bottom end and ceramic-to-silicon material bearings and bearings. These pumps can be used in semi-body applications. mode, with flow rates up to liters/minute. Standard fittings available for hose, thread or kit. Series (carbon fiber reinforced type) is a material for the pouring end of small magnetic drive pumps suitable for transporting hazardous chemicals, and is suitable for transporting high-hazardous chemicals. mode, with flow rates up to liters/minute. Standard fittings available for hose, thread or kit. Series (glass fiber reinforced plastic filled polypropylene type) Series (natural polyvinylidene fluoride material) Series (carbon fiber filled type) Microcomputer control, DC brushless motor, solid flow rate and variable flow rate magnetic drive pump. Magnetic drive pump equipped with DC brushless motor, printed circuit board and variable flow speed controller. The materials are available or meet different needs. Able to accommodate external milliamp current changes to maintain constant flow and head for varying pH values. The motor efficiency is twice that of AC motors. save space. Series of magnetic drive pumps for general purpose OEM and their general applications. Variable flow rates up to liters/minute. Suitable for hose, threaded and flange connections. Polypropylene pouring material, reducing costs. Series (polytetrafluoroethylene) magnetic actuator for conveying hazardous chemicals, suitable for polyethylene pouring body material of hazardous chemicals. This model has a maximum flow rate of liters/minute. Suitable for hose, threaded and flange connections. Series magnetic drive pumps are made of general purpose polypropylene pourable material. Types, flow rate up to liters/minute, lift meters. It can transport many types of chemicals, and the maximum temperature can reach ℃. Suitable for international electrician standard motor, power. Suitable for flange connections.
Vertical multi-stage centrifugal pump/
The original text is reproduced from Asia Fluid Network. Please indicate the source for reprinting.